Combined ultrasonic sensor, temperature sensor, ultrasonic servo circuit and transmitter circuit.
Adopts SMD components, ASC chip and plated circuit boards, ensure the product with small volume but good long term reliability.
NLEPF compound material housing, endurable and with good acoustic property.
Suitable for most of sites and user friendly.
GUT745 ultrasonic level sensor is a combination of ultrasonic sensor, temperature sensor, ultrasonic servo circuit and transmitter circuit. It uses SMD components and ASC chip, which makes the circuit compact and concise. The circuit board is plated and has high stability and long-term reliability. Meanwhile, the shell uses NLEPF synthetic materials with sturdy texture and good acoustic property. The transducer can be used in most working condition sites. While fixing it on the liquid wall or instrument housing, there is no need tools such as screws, but a 68mm hole. It has the features of stabilization, easy installation and disassembly.
Low power sensor
Middle power sensor
Non detection zone (NDZ):
When FS≤3m, NDZ could be customized to 200mm, 15mm or 100mm
When FS≤5m, NDZ could be customized to 200mm or 15mm
Can not be customized
In case that value of ±0.5%F S is less than 5mm, take 5mm as accuracy; if not, accuracy will be ±5mm.
(at 25℃, absolute flat surface target under standard condition)
When FS≤1m, accuracy could be customized to ±1mm
When FS≤2m, accuracy could be customized to ±3mm
When FS≤7m, accuracy could be customized to ±0.25%F.S
Default: 4-20mA three wires
4-20mA four wires, 0-20mA, 1-5V, 0-5V, RS485 (default MCU protocol of our company), 4-20mA+RS485, 1-5V+RS485
Users could not set address and communication baud rate since the product do not have display.
Default setting: Address=01, communication baud rate=9600bps
Please inform us before order if you have other requirement on setting.
Default: Distance mode, i.e. output for distance between end of sensor and the target surface
Liquid level mode, i.e. output for distance between surface and bottom (bottom of the container) of the liquid
Please inform us for height of installation before order. To avoid installation error, please make sure the installation height provided consists with distance between end of sensor and bottom of liquid.
DC12V/300mA, no customization option
Customization: Negative temp. 10℃, -20℃, -30℃; High temperature 60℃, 70℃, 80℃
Default: 0.5m length, please inform us if you need other length
Default: screw or clamp
Size of screw: M49x1.5mm, 2 clamps
IP65, no customization option
Default: normal pressure, non explosion proof, no corrosion condition
Customization: Intrinsically safe, strong corrosion resistance (PTFE material used)
Please consider condition of the surface and real site before doing type selection. For waving surface and some special conditions on site, larger range may need to be chosen.